Italpresse Automatic Edge Gluing Press Line for Beams with RF Curing Fast/1300

1) MOTORIZED ROLLERS TABLE WITH SIDE AND VERTICAL PUSHERS - Placed before the gluing station to drive and hold the strips to make easier the spreading of the same.

• width mm 200
• length mm 1400
• feeding speed mt/1‚Äô 30-100

2) SPECIAL VERTICAL SPRAY GLUE SPREADER - To glue the strips, with an electronic control to allow the gluing of a fixed and programmed number of strips.

• max useful height mm. 120
• complete with airless pump

3)SINGLE STATION MOTORIZED ROLLER TABLE - To receive the glue strips and transfer them parallely to the feeder, to allow the automatic composition of the panel on the composition table.

• gear motor Kw. 0,37
• rollers diam. mm. 76
• feeding speed mt./1‚Äô 30-100
• width mm. 200

4) PNEUMATIC FEEDER BAR - To allow automatically the composition of the panel in longitudinal way.

• max stroke mm. 150

4.1) FENCE - With manual backstroke which accompanies step by step the composition of the wood strips on the loading table and prevents them from falling.

5) MOTORIZED LAY-UP TABLE - Made with “V” shaped profiles to grant a proper loading of the wood strips into the press.

• dimensions mm. 1300x4200

6) PRESS suitable for Radio Frequency (RF generator excluded)

• frame made with welded beams
• platens dimensions mm. 1300x4000
• platens No. 2
• daylights No. 1
• total opening mm. 250
• stroke mm. 250
• loading side mm. 1300
• downstroke movements of the platens
• upper platen covered with aluminium
• total thrust Tons. 150
• no. 8 thrust cylinders diam.mm. 85
• no. 2 movement cylinders to speed up the opening and closing of the mobile platen
• limit switch to adjust the daylight opening
• belt speed inside the press mt/1‚Äô 0-40
• belt control with gear motor group and inverter

6.1) HORIZONTAL SIDE CYLINDERS GROUP ASSEMBLED ON PROPER BEAM

• no. 8 fixed horizontal cyilinders complete with pusher and safety system control
• total thrust Ton. 100
• manual exclusion for each cylinder
• fence on the opposite side

7) FREE ROLLERS TABLE

- dimensions mm. 1300x4000

OPTIONALS

- SIDE PUSHER (thickness on request)

- No. 1 ADDITIONAL HORIZONTAL CYLINDER

- MANUAL VERTICAL MICROMETIC ADJUSTMENT of the support for the horizontal cylinders from 0 to 60 mm.

- MOTORIZED VERTICAL MICROMETIC ADJUSTMENT of the support for the horizontal cylinders from 0 to 60 mm.

- PNEUMATIC CYLINDERS fixed on the opposite side fence to grant, when press cycle is over, the detaching of the pressed blackboard panels.

- MANUAL EXCLUSION of each cylinder row

- AUTOMATIC SPRAYING SYSTEM on both platens of special anti-gripping grease, to ease the detaching of the panels at the end of the gluing phase and to keep platens clean.

- CONNECTION BETWEEN RADIO FREQUENCY GENERATOR AND THE PRESS

- earth connection of the system made of aluminium strips and galvanized steel strips all around the press perimeter.

- connection between positive pole of the generator and bottom isolated platen of the press

- CE SAFETY STANDARDS for the press system when radio frequency generator is located on the opposite side of the horizontal cylinder.

- CE SAFETY STANDARDS for the press system when radio frequency generator is located on the same side of the horizontal cylinder.